|
|
- Harder than UHMW
- Better resistance to compression : 2000 psi maximum
- Internal lubricant : MoS2 (molybdenum disulfide)
- Good resistance to abrasion and impact
- Designed for very abrasive environments (compared to Nyloil)
- Absorbs little water
- Surpasses brass
- Typical applications :
- Bushings
- Dust-exposed wear pads
- Low velocity : 400 pi/minute maximum
- Continuous use temperature : 100 degrees C maximum
- Available in sheet, rod and tube, according to your needs
- Better performance than MoS2 in clean or sealed conditions
- Absorbs little water
- Better than brass
- Excellent resistance to wear, metal/plastic (internal lubricant)
- Typical applications :
- Bushings
- Swivels
- Gears
- Boom truck pads
- Bearings
- Same condition as MoS2 :
- 2000 psi maximum
- 400 pi/minute maximum
- 90 degrees C maximum
- Available in sheet, rod or tube, according to your needs
info@plastiquesgplus.com
|
